1. Chemicals
AZD6244 (selumetinib) was purchased as a research agent from the Selleckchem Chemicals LLC (Houston, TX, USA). AZD6244 (selumetinib), originally developed by AstraZeneca, is a highly potent and selective non-ATP competitive inhibitor of MEK with an IC50 of 14 nM37. Bleomycin Sulfate, Streptomyces verticillus, was purchased from Sigma (St. Luis, MO).
2. Animals, bleomycin-based skin fibrosis, and treatment
Areg knockout and C57Bl/6 mice were purchased from Jackson laboratory (Bar Harbor, ME). Use of animal was approved by the IACUC committee in Indiana University School of Medicine (ethical code 11370; approval date—15 February 2020). We mated Areg knockout and C57Bl/6 mice over 7 generations to obtain Areg knockout and wild type mice in a similar genetic background. Genotyping of mice was performed by PCR with specific primers provided by the vendors using lysed tail from each mouse [0.3 cm tail in 100 mL of PCR Direct (tail) solution (Viagen Inc., Los Angeles, CA) with 1 mg/mL proteinase K at 55°C overnight, then 85°C for 45 minutes, and use 0.5–1 microL of the lysate for each 25 microL PCR reaction].
Skin fibrosis was generated according to a previously published protocol 38. In brief, bleomycin was made in PBS in 1mg/ml, and intradermal injection was performed using gauge needle #27 with 50microL/injection onto the back of mouse skin (at low right side) after fur removal. At up left, we used PBS for injection after fur removal. The procedure was approved by the IUCUC Committee in Indiana University School of Medicine and was strictly followed in the study. We injected mice daily for 10 days before harvesting skin tissues for analyses in skin thickness, gene expression and histology [hematoxylin and eosin (H&E) staining and Immunofluorescence (IF)]. In bleomycin-induced skin fibrosis studies, we used 10 mice per group (control PBS injection or bleomycin injection, 5 females and 5 males). We used 3 mice for AZD6244 (selumetinib) treatment, and 5 mice for the control group.
AZD6244 was suspended in sterile PBS by sonication at 5 mg/mL. For drug treatment, mice were treated with AZD6244 (oral gavage 10 mg/kg daily) or vehicle control (PBS) in each group.
3. Histology, IF staining and tissue measurement
Histology was performed according to a previously published procedure39. Fresh tissue was harvested and fixed with 10% buffered-formalin or zinc-based fixative. Five-micron paraffin-embedded sections were labeled with primary antibodies against phosphor-p44/p42 MAPK (Erk1/2) (Thr 202/Tyr 204) (Cell Signaling Technology Cat# 4370, 1:200, Danvers, MA, USA), Ki-67 (ab15580, 1:500, AbCam, Cambridge, MA, USA).
The skin thickness was quantified using ImageJ. To avoid discrepancy from age and genetic backgrounds of the mice, we used littermates from the same mating cage for selection of treatment groups or genotypes. Because of the variation between back skin and abdomen skin in tumor development, we used back skin for injection and histology studies.
4. RNA Extraction, RT-PCR and Real-Time PCR
Total RNAs from tissues were extracted using Tri-RNA reagent from Sigma (St Luis, MO) according to the manufacturer’s instruction and 1 microG of total RNA was reverse transcribed into cDNAs using the first-strand synthesis kit (Roche, Tucson, AZ, USA). Real-time quantitative PCR analyses were performed according to a previously published procedure 39. Triplicate CT values were analyzed in Microsoft Excel using the comparative Ct(DDCt) method as described by the manufacturer (Applied Biosystems, Foster City, CA, USA). The amount of target (ddCt) was obtained by normalization to an endogenous reference (Gapdh for mice) and relative to a calibrator. All TaqMan primers and probes were purchased from Applied Biosystems Inc.
5. Single cell RNA-seq, Sequence Alignment, Differential Expression Analyses Tissue was dissociated with Collagenase IV 1mg/ml 37C for 1 hour. Cells were washed with 5%FBS/PBS twice, each centrifuged (1000rpm), and dead cells were removed by dead cell removal kit (Miltenyi Biotec, Somerville, MA). Prepared cells were used to perform 10X Genomics according to a previously published protocol40. In brief, appropriate number of cells were loaded on a multiple-channel micro-fluidics chip of the Chromium Single Cell Instrument (10x Genomics) with a targeted cell recovery of 9,000. Single cell gel beads in emulsion containing barcoded oligonucleotides and reverse transcriptase reagents were generated with the v3.1 Next GEM Single Cell 3ʹ reagent kit (10X Genomics). Following cell capture and cell lysis, cDNA was synthesized and amplified. Illumina sequencing library was then prepared with the amplified cDNA. The resulting library was sequenced using a custom program on Illumina NovaSeq 6000. 28 bp of cell barcode and UMI sequences and 91 bp RNA reads were generated with Illumina NovaSeq 6000 at CMG of Indiana University School of Medicine. Sequencing analyses were performed as previously reported 41.
6. Statistical analyses Data are presented as mean SD. Statistical analyses were performed using the Mann–Whitney test or the Student t test (two-tailed) to compare the results, with P values of < 0.05 as statistically significant.