Study site
Mosquito collections were done in three different villages, namely; Ikwambi (7.98033°S, 36.81701°E) and Sululu (8.00324°S, 36.83118°E) in Kilombero district, and Tulizamoyo village (8.35747°S, 36.70664°E) in Ulanga district, south-eastern Tanzania (Figure 1). The main malaria vectors in this area include An. arabiensis and An. funestus, with the latter driving more than 80% of the malaria transmission [28,29]. This area has had high coverage of pyrethroid-treated nets for several years, but no IRS is implemented. The villages are all in low altitude areas, rising not more than 500m above sea level. Mean daily temperatures are 20-33°C, annual rainfall, 1200-1800 mm and relative humidity ranged between 24 and 97% [46,47]. Most community members here are farmers, cultivating rice, maize and other crops in the Kilombero river valley.
Figure 1: Locations of the study sites in Kilombero and Ulanga districts, where adult mosquito collections were performed.
Mosquito collection
The World Health Organization (WHO) protocol for insecticide susceptibility tests [18] was used with slight modifications to conduct the basic bioassays and the resistance intensity assays. Since An. funestus mosquitoes were difficult to find as larvae across all the study villages, young nulliparous adult females for both An. funestus and An. arabiensis were used instead of larval collections. Mosquitoes were collected from September 2018 to November 2019 using CDC light traps [48]. Collections were done from 07.00 pm to 07.00 am each night. To maximize probabilities of getting young unfed nulliparous females, houses near the edges of the villages and near potential habitats were selected for collections, based on previously-described heterogeneity of malaria transmission [49].
The traps were hung beside human occupied bed nets [50], but with extended catch bags to improve survival of the mosquitoes for subsequent assays. Each morning, after collections, the mosquitoes were transported to the Ifakara Health Institute’s mosquito biology laboratory, VectorSphere, in Ifakara and maintained at 27 ± 2°C and 80 ± 10% relative humidity for 24 hours to acclimatize as previously described [45]. During the acclimatization period, mosquitoes were supplied with 10% glucose solution. The mosquitoes were identified morphologically using the Gillies and Coetzee identification key [51], and non-target species were discarded. Tests were conducted using only non-blood-fed An. funestus and An. arabiensis females.
Bioassays
This study incolved three steps: i) susceptibility assays to examine phonotypic resistance against standard insecticide doses, ii) tests to assess intensity of resistance against chemicals to which resistance had been detected at baseline level, and iii) tests using synergists to assess possible mechanisms of the observed reistance.
Baseline insecticide susceptibility bioassays were done according to WHO guidelines [18]. Candidate insecticides were selected from four classes as follows: organophosphate (0.25% pirimiphos-methyl), organochloride (4% DDT), carbamate (0.1% bendiocarb), pyrethroid type I (0.75%, 3.75 & 7.5% permethrin) and pyrethroid type II (0.05%, 0.25 & 0.5% deltamethrin). In each test, 120 mosquitoes were exposed to the insecticide-impregnated papers, and oil-impregnated papers as controls. Each test comprised six replicates (four treatments and two controls) with the total of 120 mosquitoes. Mosquitoes were exposed for one hour and the knockdown time recorded at an interval of 10, 15, 20, 30, 40, 50, 60 minutes. They were then transferred to holding tubes, provided with 10% glucose solution, and their mortality recorded after 24 hours.
Where resistance was observed in the baseline assays with standard diagnostic doses (i.e. 1×), additional tests were done to assess intensities of the resistance using 5× and 10× multiplicative doses of the insecticides. These included tests against 3.75% & 7.5% permethrin, and 0.25% & 0.5% deltamethrin. The procedures were similar to the baseline tests for assess mortality.
Lastly, 4% Piperonyl Butoxide (PBO), a synergist, was used to assess the possible resistance mechanism by attempting to reverse the observed mortality outcomes [18]. Each test had four groups, each with 80 mosquitoes (in groups of 20), treated as follows: the first cohort was exposed to 4% PBO for one hour and immediately exposed to deltamethrin or permethrin for 60 minutes, a second group was exposed directly to the respective insecticides (i.e. deltamethrin, permethrin), a third group was exposed to the PBO only and the fourth group was exposed to control papers impregnated by silicone oil but no insecticide nor synergist. Given test kit limitations, the PBO tests were done only for pyrethroids.
Molecular identification of sibling species of the tested mosquitoes
Up to 10% of the mosquitoes from each bioassay were packed separately and labelled with information about experimental date, village name, type of insecticide, insecticide dose used, species of mosquito, replicate number and sample ID. The packed mosquitoes were sent to the laboratory for molecular species identification of sibling species in the An. funestus and An. gambiae s.l. complexes, using DNA extracted from the mosquito legs. Polymerase chain reaction assays were conducted based on species-specific nucleotide sequences of the ribosomal DNA (rDNA) by relying on the intergenic spacer regions (IGS) for An. gambiae s.l. members and the non-coding internal transcribed spacer 2 region (ITS2) for An. funestus [52,53]. DNA bands were photographed under ultraviolet light using Kodak Gel Logic 100 imaging system [54].
Data analysis
The data on insecticide susceptibility was interpreted based on the WHO-specified thresholds for resistance determination [18]. Susceptibility was confirmed when mortality was ≥ 98%, possible resistance was determined when mortality ranged from 90% - 97%, in which case the tests were repeated for confirmation, and resistance was confirmed when mortality was < 90%. When mortality greater than 10% was observed in controls, the test mortality was corrected using Abbott’s formula to avoid the biased estimations [55]. Tests were discarded and repeated, whenever control mortality exceeded 20% [18]. Final results were plotted in graphs using R software version 3.0 [56]. Log-probity analysis was used to calculate mean duration at which 50% (KD50) and 95% (KD95) of mosquitoes exposed to specific insecticides were knocked down.