The aim of this paper is to investigate the influence of different exit geometries of the nozzle in the FLM process. In order to determine the effects of nozzle exit shapes, an experimental investigation was carried out. Individual strands were deposited with different nozzle exit shapes, whose shape was sub-sequently determined by laser scanning and microscopic images of the strand cross-sections. In addition, the orientation in relation to the deposition direction and five different layer heights were investigated. Circular, triangular, square, and hexagonal nozzle exit shapes with cross-sectional areas equivalent to a cir-cle of 1 mm, 0.8 mm and 0.6 mm diameter were prepared for these tests. Strands were printed with these different geometries and then scanned with a laser scanner and examined in cross-section with an optical microscope. After-wards, the strand shapes were compared with each other using the created pro-files and strand cross-sections. The results show that different geometries of the nozzle exit lead to different shapes of strand cross sections. It can be observed that the deviation from the cross section of the circular nozzle decreases with an increase in the number of corners of the nozzle geometry. Furthermore, the ex-tent of the deviation increases with increasing layer height. In addition to the outlet shape, a different orientation of the same nozzle leads to a deviating strand cross-section. Especially with the triangular nozzle exit geometry, this made a big difference in the shape of the deposited strand.