Study design
The Animal Ethics Committee of the Third Hospital of Hebei Medical University approved this study (approval number: Z2019-005-1). Four-week-old female Sprague–Dawley rats were obtained from the Laboratory Animal Center of Hebei Medical University. Rats have been shown to require 12 weeks of bone development to reach a mature state [26]. In this study, 120 rats were randomly separated into control and experimental groups (n=60 per group). In the control group, the rats’ left knees did not undergo any surgery. In the experimental group, the rats’ left knees underwent surgery to induce patellar instability. Rats were sacrificed by overdose anesthesia at 4, 8, and 12 weeks after surgery. Left distal femur tissues were collected after surgery (n = 20 knees/time point in each group).
Surgical technique
In this study, pentobarbital sodium (30 mg/kg, intraperitoneal injection) was used to induce anesthesia in all rats; they were then shaved and disinfected. An incision was then made along the midline of the skin; the skin and subcutaneous tissue were separated, exposing the joint capsule through the medial approach to the knee. The procedure to induce patellar instability was performed as described in our previous studies [24, 25]. Specifically, a 0.5-cm longitudinal incision was made along the patella at the medial capsule and retinaculum. In this manner, patellar instability could be observed during surgery. All procedures were carefully performed to avoid cartilage damage. The incision was carefully flushed, then sutured. Finally, the wound was bandaged. To control postoperative pain, rats were administered acetaminophen (30 mg/kg, daily) for 5 days.
Macroscopic morphological and micro-computed tomography (CT) assessment
All distal femurs were carefully harvested and scanned via micro-CT (SkyScan model 1076, SkyScan, Kontich, Belgium; parameters: 10 μm voxel size at 50 kV and 800 μA) at 4, 8, 12 week after surgery, respectively. As described previously [12, 24], axial slices of the trochlea were identified; trochlear depth and sulcus angle were then calculated (Figure 1). Using the diagnostic criteria defined by Dejour et al. [4], TD was diagnosed in micro-CT images.
For analysis of microstructural parameters, the region of interest was located transversely below the lateral and medial facets of the trochlea with two red cylinders of 3-mm diameter (Figure 1); micro-CT scanning data were transformed into a three-dimensional model by using Mimics software, version 19.0 (Materialise, Leuven, Belgium). Microstructural parameters analyzed in this study included bone volume to total volume fraction (%), trabecular number (1/mm), trabecular thickness (mm), trabecular separation (mm), and bone mineral density (mg/cm3).
Histological staining
Samples were isolated at each time point, fixed with 4% paraformaldehyde, decalcified in 10% ethylenediaminetetraacetic acid until completely demineralized, and embedded in paraffin. Five-micrometer slices were cut along the femoral axis to obtain axial images of the trochlear groove. Glycosaminoglycans in cartilage were assessed using Safranin O; evaluation of cartilage degradation was performed by fast green counterstaining of protein. The modified Mankin scale was used to determine the grade of cartilage degeneration [27].
Immunohistochemistry
Slices were deparaffinized in xylene and rehydrated. At room temperature, slices were washed three times with phosphate-buffered saline (5 minutes per wash). Endogenous peroxidase activity was blocked by incubation of slices in 3% hydrogen peroxide for 10 minutes. Antigen retrieval was performed by microwave treatment of slices for 10 minutes in 10 mM sodium citrate (pH 6.0). Slices were incubated overnight at 4℃ with anti-PI3K (BoAoSen, Beijing, China), anti-AKT (Servicebio, Wuhan, China), anti-TGFβ1 (BoAoSen), or anti-ADAMTS-4 (BoAoSen) primary antibodies at a dilution of 1:50. For the negative control, the primary antibody step was omitted. Subsequently, the objective magnification was adjusted to 20 × 100, five regions were randomly selected for all slices in each group, and the entire area of each region was imaged. During microscopy, the tissue covered the entire field of view; the background light was maintained at a consistent level. Image-Pro Plus 6.0 software (Media Cybernetics, Rockville, MD, USA) was used for analysis of all microscopy images. All images were analyzed to acquire data regarding cumulative optical density and tissue area. The areal density was defined as cumulative optical density divided by tissue area. The areal density value is positively correlated with positive protein expression.
qPCR
Samples were analyzed by qPCR to determine mRNA expression levels at 4, 8, and 12 weeks after surgery. Trizol reagent (Servicebio) was used to extract RNA from chondrocytes and cartilage. The RevertAid™ first-strand cDNA synthesis kit (Cat. No. K1622, Thermo Fisher Scientific, Waltham, MA, USA) was used for reverse transcription of mRNA into cDNA. Primers for PI3K, AKT, TGFβ1, and ADAMTS-4 were used, with a sequence detection system for gene analysis. mRNA expression of target genes was determined with reference to GAPDH and calculated using the formula 2-ΔΔCt (cycle threshold method). All primers used in this study are listed in Table 1. Each experiment was performed three times and mean values were used for further analyses.
Statistical analysis
Mean and standard deviation were used for descriptive statistical analysis. The Shapiro–Wilk test was used to determine normality for each variable, while Levene’s test was used to assess homogeneity of variance. Student’s t-test was used for comparisons between two groups; one-way analysis of variance was used for comparisons among ≥3 groups. SPSS Statistics, version 19.0 (IBM Corp., Armonk, NY, USA) was used for all statistical analyses. Differences with p < 0.05 were considered statistically significant. Preliminary analysis suggested that at least six rats were needed at each time point and in each group, to achieve 80% efficacy (1-β) and 90% confidence [28].