Study design, area and sample population
This was a descriptive cross-sectional study enrolling 150 TB suspected patients who visited District Public Health Laboratory (DPHO), Bharatpur, Chitwan over 2 months from January to February, 2020. The patients were asked to collect early morning sputum sample in a clean dry and leak-proof container and bring it cautiously to DPHO laboratory.
Sample collection and transport
Immediately after collecting the sputum, each sample was observed microscopically for the presence of AFB bacilli by Ziehl-Neelsen staining at DPHO laboratory. The samples were then transported aseptically to the Microbiology laboratory of Birendra Multiple Campus for bacteriological investigations within half an hour. A little of each AFB positive sample was left at the DPHO laboratory for further analysis by Genexpert method.
Culture and identification of the isolates
The methodology was followed according to a similar study done by Ngekeng [7]. A loopful of the uncentrifuged sample was streaked over Chocolate agar, Blood agar, MacConkey agar and XLD agar (Hi-Media, India) under laminar airflow conditions. Duplet culture was performed to ensure that bacterial growth was not from contamination of media. Blood agar was incubated at anaerobic condition and Chocolate agar, MacConkey agar and XLD agar were incubated at the aerobic condition for 24 h at 37ºC. Bacterial colonies were further subcultured until pure culture was obtained. Identification of bacterial isolates was done based on their morphological and biochemical characteristics [12].
Antibiotic susceptibility testing
The bacterial isolates were subjected to Antibiotic Susceptibility Test (AST) by modified Kirby Bauer's disc diffusion method following CLSI guidelines (2016) [13]. Altogether, 17 different commonly used antibiotics procured from Hi-Media, India were used for testing. AST was performed for all the isolates and the zone of inhibition was measured and interpreted following CLSI guidelines (2016) [13]. In case of Bacillus spp., AST was performed as suggested by Charteris et al [14]. Resistance to at least one drug from 3 different antibiotics of different structural classes was considered MDR as described elsewhere [15].
Screening of ESBL and MBL producers
Primary screening of ESBL producers was done by using ceftazidime (CAZ) (30µg) and cefotaxime (CTX) (30µg) disks (Hi-Media, India). If the zone of inhibition was 22mm for CAZ and/or 27mm for CTX, the isolate was considered a potential ESBL-producer as recommended by NCCLS [16]. Combination disk method [17] was used to confirm ESBL-producing isolates in which CTX and CAZ (30µg), alone and in combination with clavulanic acid (CA) (10µg) were used. An increase in ZOI of 5mm for either antimicrobial agent tested in combination with CA versus its zone when tested alone confirmed ESBL [13].
Imipenem resistant Gram-negative isolates were selected for the further detection of MBL production by disc potentiation method as previously described [29]. Briefly, bacterial isolates (adjusted to 0.5 McFarland turbidity standards) were aseptically swabbed on Mueller-Hinton (MH) agar plates and standard antibiotic disks of imipenem (10 µg) and meropenem (10 µg) impregnated with EDTA (1 µg) was aseptically placed on MH agar plates. Supplementary imipenem (10 µg) and meropenem (10 µg) disks without EDTA were also placed alongside the antibiotic disks impregnated with the chelating agent (EDTA) at a distance of 20 mm apart. All plates were then incubated at 30°C for 18-24 h and zone of inhibition were recorded after incubation. A difference of ≥ 7 mm between the zones of inhibition of any of the carbapenem disks with or without the chelating agents was considered as metallo β-lactamase production [29].
Quality control
Each batch of media and reagents was subjected to sterility and performance testing. During antibiotic susceptibility test, quality control was done using the control strains of E. coli ATCC 25922.
Data management and statistical analysis
All the raw data obtained in this study were tabulated in SPSS V.20 and Chi-square test was performed. P ≤ 0.05 was assigned as significant.