This study was conducted according to National Institutes of Health guide for the care and use of Laboratory animals (NIH Publications No. 8023, revised 1978) and all the procedures were done after the approval of the Institutional Animal Experimental Ethics Committee of Sichuan University (Chengdu, China, Approval NO.2017041A).
2.1 Experimental animals
Adult male Sprague-Dawley rats weighing 230-300 g (n = 18) provided by Chengdu Dossy Biological Technology Co., Ltd (Chengdu, China) were housed in separate cage with food and water freely. The room has 24°C maintained temperature with a 12-hour light/darkness cycle. All experiments were performed during 8 am to 4 pm on each test day and all behavioral assessments were performed in the morning.
2.2 Intrathecal catheter implantation
The procedure of intrathecal (i.t.) catheter insertion was carried out as described in our pervious study[11]. In brief, pentobarbital sodium (60 mg/kg, i.p.) was used to anesthetize rats. Then cervical and lumbar dorsal skin was sterilized with povidone-iodine. An incision about 1.5cm on the middle line of lumbar skin (L4–S1) was made. The bilateral muscle along L5 spinous process was cut. Then the L5 spinous process was removed and the intervertebral membrane between L4 and L5 was exposed. The ligamentum flavum was then punctured by a 22gauge needle following a sterile polyethylene (PE-10) catheter was inserted into the subarachnoid space rostrally about 2cm length. The catheter was fixed to the muscle and anadesma, and the proximal ends of the catheter were tunneled underneath the skin and exist out to the cervical region. After injecting 5μl saline to ensure patency of the catheter, the tip of the catheter was sealed via fusing. The wounds were sutured layer by layer by 5-0 surgical sutures. The animals were allowed to recover for 3 days in individualized cages before use. The correct placement of the catheter was then verified by observing symmetrical lower limbs paralysis induced by intrathecal injection of 10μl 2% lidocaine and completely recovered from the spinal anesthesia on the fourth day after surgery. The animals showing any signs of prolonged motor impairment after the spinal anesthesia were excluded. The correct placement of the catheter in the subarachnoid space at the lumbar enlargement was confirmed by dissection at the end of experiment.
2.3 Drug and vehicle administration
Morphine hydrochloride (Shenyang First Pharmaceutical Factory, Shenyang, China) was dissolved in saline. Chelerythrine was dissolved in Dimethyl Sulfoxide (DMSO). Eighteen rats were divided randomly into three groups, Saline(Sal), Morphine(Mor) and Morphine+ Chelerythrine (Mor+Che) (n=6, each). The Mor group received twice-daily i.t injections of morphine (15μg/10μl) followed by a flush of 10μl saline delivery into the subarachoid space for consecutive 9 days(twice a day at 9AM and 4PM, respectively) using a microinjection syringe (Gaoge, Shanghai, China). The Mor+Che group received twice-daily i.t injections of morphine (15μg/5μl) and chelerythrine (5μg/5μl) followed the same flush as Mor group. The Sal group received the same amount of 20μl saline, but no morphine, in the same fashion as done for the morphine group.
2.4 Behavioral assessments
Prior to the first behavioral test, rats were adapted to the testing environment for 3 h per day for consecutive 5 days. Habituation covers the process of moving rats from feeding room to the testing room and then they were kept in the testing equipment for 3 h. The behavioral test was implemented by a researcher blinded to the rat groups. Mechanical hindpaw withdrawal threshold and thermal withdrawal latency of all animals were recorded on the 1, 3, 5, 7, 9 day respectively during drugs injection. The baseline nociceptive thresholds (mechanical withdrawal threshold followed by thermal withdrawal latency) on right hindpaw of each group were determined prior to drugs administration on each designated test day. The thermal withdrawal latency was measured again 30min after the first drug or vehicle administration per day between 9:00 am to 10:00 am. After the final behavioral test, rats were euthanatized by anesthetization with pentobarbital sodium (60 mg/kg, i.p.) followed by cervical dislocation and the L3-L5 spinal cord were harvested.
2.4.1 Mechanical allodynia
Mechanical withdrawal threshold (MWT) was measured via a von Frey filament marked with a calibrated range of bending force (0.6, 1, 1.4, 2, 4, 6, 8, 10, 15, and 26 g) as described previously. Each rat was put into a plastic cage having a wire mesh bottom and allowed to acclimate for 30 min before measurement. A single von Frey filament was applied vertically to the region between feet pads in the aspect of right hind paw plantar for five times with an interval of 5 s. At least one distinct withdrawal response out of five applications was treated as a positive record. Filaments were used in an up-and-down rule in accordance with a negative or positive response to determine the hindpaw withdrawal threshold.
2.4.2 Thermal hyperalgesia
Thermal withdrawal latency (TWL) to radiant heat was determined according to a previously described method using a thermal testing apparatus (Ugo Basile, Plantar Test 37370, Italy). Rats were placed individually into plexiglas cubicles placed on a transparent glass surface and allowed to acclimate for 30 min before testing. The light beam from a projection bulb which was located below the glass was directed at the region between feet pads in the plantar aspect of right hindpaw. The period from the beginning of radiant heat stimulation to withdrawal of the hindpaw was regarded as hindpaw withdrawal latency. The baseline latency of about 12 s and a cut-off time of 20 s which was set to prevent thermal injury. Three trials with an interval of 5 min were made and scores from three trials were averaged to yield mean withdrawal latency. The measurements were implemented both before and 30 min after morphine administration.
2.4.3 Morphine tolerance
The morphine tolerance was depicted as the percentage of maximal possible antinociceptive effect (%MPAE) in the morning from day 1 to 9 and on day 10. The %MPAE was calculated as %MPAE= [(Test PWL-Basic PWL)/ (cutoff time-Basic PWL)] × 100. Cumulative dose-response curves were determined on day 10 after long-term morphine and saline administration according to previously described method[11]. Rats were firstly administrated with a low dose morphine (10μg) followed by antinociceptive effect assessment 30 minutes later through TWL test and then received a next dose (cumulative dosing increase by 2-fold) and were tested again 30 minutes afterward until the rats couldn’t feel the stimulation so that failed to move the hindpaw within the cutoff time.
2.5 ELISA
On day 10, all rats were deeply anesthetized with pentobarbital (60 mg/kg, i.p.). The blood was taken from ventriculus dexter in the afternoon to minimize fluctuation of the serum melatonin level. The blood was centrifuged at 1500rpm for 15min and the serum was obtained and placed in EP tubes wrapped with aluminum foil for protection from light and stored at −80 °C until use. The level of serum melatonin was assayed though a rat-specific ELISA kits (XL-Er1047, YonghuiBiological Technology Co., Ltd, Beijing) according to the manufacturer’s instructions.
2.6 Real-Time (RT)-PCR
A part of tissues harvested from each rat for preparation of western blot were used for RT-PCR. Firstly, the tissues were isolated for the total RNA extraction. Single-strand complementary DNA was designed using Primer Premier 6.0 and synthesized by Sangong Biotech (Shanghai,China). All complementary DNA samples were stored at -80°C before using. RT-PCR was performed using a PikoReal Real-Time PCR System (PIKORed 96, ThermoFisher, US). Relative messenger RNA (mRNA) levels were calculated according to the 2- △△CT method. Oligonucleotide primers were used as Table1.
Table 1. Sequences of primers for RT-PCR
Target gene
|
Forward primers
|
Reverse primers
|
β-actin
|
gaagatcaagatcattgctcct
|
tactcctgcttgctgatcca
|
MT1
|
tgtcgcttacaccgttgctccagat
|
ggcagcagcactgttcgtcacttca
|
MT2
|
tgatctccaactgccgcctccattc
|
agctgcacttgtccaaagcctctt
|
MOR
|
tctcttctgccatcggtctgcctgt
|
tacagccacgaccaccagcaccat
|
PKCγ
|
ggttcaccgccgatgccacgaatt
|
ctctgtatggtccacgccgcaaagg
|
2.7 Western blot
Pentobarbital (60 mg/kg, i.p.) was used to anesthetize rats in each group (n = 3/6) and decapitation was performed for rapid tissue harvesting. The L3-L5 segment of the spinal cord was first divided into the right and left side and then further separated into the dorsal and ventral horn, respectively. Tissue samples were homogenized in RIPA buffer (50mM Tris (pH 7.4),150mM NaCl,1% NP-40,0.1% sodium deoxycholate) and were allowed to homogenize for 10min on fragmentized ice. The samples were centrifuged at 4°C for 15 min at 12000rpm. The protein concentration of the supernatants was assayed via a BCA protein assay kit (KGP903, KenGEN BioTECH, Jiangsu, China). Supernatants (50μg) were warmed for 5 min at 100°C in loading buffer (50 mM Tris–HCl, 2 %SDS, 2 % β-mercaptoethanol, 8 % glycerol, and 0.1 % bromophenol blue) and resolved by SDS-PAGE on 10 % polyacrylamide gels. After gel electrophoresis, proteins were electrophoretically transferred to PVDF membranes (HYBOND, Inc.USA). The membranes were blocked via 5%BSA in Tris-buffered saline (TBST) with 0.1 % Tween 20 for 2 h and incubated overnight at 4 °C with a primary antibody to MOR(1:200, ab10275, Abcam, Cambridge, UK), MT1 (1:500, NBP1-71113, Novus Biologicals, US), MT2 (1:200, ab203346, Abcam, Cambridge, UK), PKCγ( 1:200,ab71558, Abcam, Cambridge, UK),β-actin (1:5,000);Membranes were then incubated in HRP conjugated secondary antibody (1:5,000; ab6721 and ab6789, Abcam, Cambridge, UK) for 2-3 h at room temperature, visualized with TBST for 3 times (10min per time), and exposed onto X-films for 1–5 min. The X-films were scanned and the density of target bands was analyzed by Image Lab (BIO-RAD, US)
2.8 Statistical data analysis
Data are presented as mean ± SEM. The SPSS 16.0 (Chicago, IL) was used to conduct statistical analysis and the figures were presented by GraphPad Prism 6.0 software (La Jolla, CA, USA). Alteration of MWT, TWL and MPAE% of day1 to day 9 between groups were assessed with two-way analysis of variance (ANOVA) (group × day)followed by the Bonferroni post hoc test for multiple comparisons. The data of ELISA, western blot, RT-PCR of each group were compared by one-way analysis of variance (ANOVA) followed by the Bonferroni post hoc test for multiple comparisons. To examine the degree of morphine tolerance, the ED50 value of morphine in each group was determined via the formula calculated form linear curve estimation when y=0.5. The up-down reversals were used to get ED50 dose and 95% confidence intervals (95% CI) of morphine anti-nociception effect and the probit analysis was applied for the three groups. P-values <0.05 was considered statistically significant.